- Special Application - SPF300 - 3/8" Seismic Pivot Fitting


SPF300 2

SPF300 3

FINISH Electro-galvanized (EG), conforming to ASTM B633 Type III SC1.
Safety factor - 3
1. Design load is limited to slip capacity of a channel nut at hole "R".
2. Allowable loads have been determined by the manufacturers testing, analysis and technical specifications at 45° from horizontal.
3. For retrofit application, engineer of record must verify.
4. Patented.
5. Square washer provided with fitting.
6. When a hanger rod is thru-bolted (in lieu of channel nut installation), higher transverse loads may be transmitted due to the higher allowed rod shear loads compared to channel nut slip values. This higher load may be used with verification through engineering calculations.

Part No. Finish Weight
SPF 300-037
SPF 300-050
SPF 300-062
SPF 300-075

Standard Dimensions:

  • Hole Diameter: 9/16" (14mm)

  • Hole Spacing (From End): 13/16" (21mm)

  • Hole Spacing (On Center): 1-7/8" (48mm)

  • Width: 1-5/8" (41mm)

  • Thickness: 1/4" (6.4mm) with steel meeting or exceeding
    ASTM A1011 SS GR 33, or

    0.220" (5.6mm) with steel meeting or exceeding
    ASTM A1011 HSLAS GR 45


  • When used for mechanical supports, load capacities of brackets and fittings should be in compliance with the American Standard Code for Pressure Piping.

Additional Specifications